Skip to Content

K 25


   SW18 3D cutting head

  Characteristics:


  •  for use with SYS 40 (with base plate FP-K25-LL).
  •  deformation-resistant aluminium
  •  reflection-poor, black anodized
  •  with clamping to fix the position.


 

Ways of installing:

 


  • with a M4 threaded hole
  • on the pin, either directly or via a base plate, in which case the slot can be used to bring the reflecting surface onto the centerline of the pin.
  •  fastening with a base plate FP-K25-LL on a slide, RT 40
  •  optionally: with a submerged fine-thread screw with a hexagon socket


 

The K 25 kinematic small mirror mounts are intended for mirrors up to ø 25 mm / 25.4 mm (1”) diameter, or when used for beam deflection for 20 x 30 mm rectangular mirrors.

 

Two fine-thread screws with a 0.25 mm pitch enable fine adjustment. Versions with micrometers are available upon request.

 

For high flexibility, the mirrors for the K-25 are glued to a glass substrate. This is wedged  into the carrier plate, and therefore a fast mirror change is possible.